Health & Safety Code § 25249.5 and following.) (This notice is provided in accordance with Proposition 65 in Cal. The cords included with this product contain chemicals, including lead, known to the State of California to cause birth defects or other reproductive harm. If you are not going to use the scanner for a long period, be sure to unplug the AC adapter from the electrical outlet. Unplug the scanner and the AC adapter before cleaning. (Do not adjust controls that are not covered by the operating instructions.) Unplug the scanner and the AC adapter, and refer servicing to qualified service personnel under the following conditions: The AC adapter or plug is damaged liquid has entered the scanner or the AC adapter the scanner or the AC adapter has been dropped or the case has been damaged the scanner or the AC adapter does not operate normally or exhibits a distinct change in performance. If there are fuses in the plug, make sure you replace them with fuses of the correct size and rating. If damage occurs to the plug, replace the cord set or consult a qualified electrician. Never disassemble, modify, or attempt to repair the AC adapter, scanner, or scanner option by yourself except as specifically explained in the scanner’s guides.ĭo not insert objects into any opening as they may touch dangerous voltage points or short out parts. Also, make sure the total ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet’s ampere rating. If you use an extension cord with the scanner, make sure the total ampere rating of the devices plugged into the extension cord does not exceed the cord’s ampere rating. Inserting a connector in the wrong orientation may damage both devices connected by the cable.Īvoid using outlets on the same circuit as photocopiers or air control systems that regularly switch on and off. Each connector has only one correct orientation. When connecting this product to a computer or other device with a cable, ensure the correct orientation of the connectors. Use only the type of power source indicated on the AC adapter’s label, and always supply power directly from a standard domestic electrical outlet with the AC adapter that meets the relevant local safety standards. Do not attempt to use it with other electronic devices unless specified. The AC adapter is designed for use with the scanner with which it was included. Using any other adapter could cause fire, electrical shock, or injury. Use only the AC adapter that comes with your scanner. Be particularly careful to keep the cord straight at the end and the point where it enters the AC adapter. Do not place objects on top of the cord and do not allow the AC adapter or the cord to be stepped on or run over. The AC adapter cord should be placed to avoid abrasions, cuts, fraying, crimping, and kinking. Place the scanner and the AC adapter near an electrical outlet where the adapter can be easily unplugged.īe sure the AC adapter meets the relevant local safety standards.
Do not place or store the scanner or the AC adapter outdoors, near excessive dirt or dust, water, heat sources, or in locations subject to shocks, vibrations, high temperature or humidity, direct sunlight, strong light sources, or rapid changes in temperature or humidity. Place the scanner close enough to the computer for the interface cable to reach it easily. Read all these instructions, and follow all warnings and instructions marked on the scanner. Must be observed to avoid damage to your equipment.Ĭontain important information and useful tips on the operation of this product. Must be followed carefully to avoid bodily injury. In this document, warnings, cautions, and notes indicate the following:
Assigning a Program to a Scanner Button.Scanning to SharePoint or Cloud Service.
#HOW TO CALIBRATE AN EPSON PERFECTION V200 MAC OS#
Using Document Capture Pro (for Windows)/Document Capture (for Mac OS X).Placing Film or Slides (EPSON Perfection V370 Photo Only).
0 kommentar(er)
